ScanningManager.Stop method

A request to ScanningManager.Stop method ends the scanning session. This method overrides the SessionInfo.StopAfter property. The ScanningManager.Stop method can be called at any point during the scanning session. The scanner stops scanning and the SessionComplete event is raised.

L_WHENTOSTOP_EOFSHEET Input Parameter

When the L_WHENTOSTOP_EOFSHEET input parameter is used when the current document is a single sheet, both sides are completed and the record is written to the output file before the termination takes effect. If the current document is a booklet, the current sheet is completed, any remaining sheets are not completed, and the record is not written to the output file. However, if invoked while on the last page of a booklet, then scanning is completed and the record is written to the output file.

NOTE: When scanning on an OpScan iNSIGHT 2 or 4 scanner, if a Stop is issued at the Clip event or any event after the Clip event, an extra sheet will be fed.

L_WHENTOSTOP_EOFDOC Input Parameter

When the L_WHENTOSTOP_EOFDOC input parameter is used, the current document is completed and the record is written to the output file.

NOTE: When scanning on an iNSIGHT 2 or 4 scanner, if a Stop is issued at the Clip event or any event after the Clip event on the last sheet of the document, an extra sheet will be fed.

Valid

See Scanning Manager States and Valid Properties/Methods

See ScanningManager Events and Valid Properties/Methods

IDL

HRESULT Stop([in, L_WHENTOSTOP_ENUM When)

Input Parameters

Exceptions

Scanning Services Exceptions

See also

How to Implement Event Driven Scanning

How to Handle General Errors