You are here: Programmers Reference > Programmer's Reference > ScanningManager > SessionComplete

ScanningManagerEvents.SessionComplete event

This event is fired at the end of a scanning session. All sheets have been cleared from the bed and the clip file and data file have already been closed. Active user exits have been unloaded at this point in time.

One use for this event is to call the ScanningManager.Quit() method to disconnect from the ScanTools Plus Link Runtime.

Another use case is post-scan batch editing or other end-of-batch custom processing of the just-scanned data file.

ScanningManager.Ping returns L_STATE_EVENTHANDLER_SESSIONCOMPLETE at this event.

IDL

HRESULT SessionComplete([in] IScanEventArgs* ScanEventArgs);

Input Parameters

IScanEventArgs with the valid properties as listed in ScanEventArgs and ScanningManager Events Valid Combinations.

Exceptions

Scanning Services Exceptions

See also

ScanEventArgs Interface Summary

ScanningManagerEvents Summary

Event Driven Scanning

 

 

See Help on Help for additional information on using this help file.

See Scantron Technical Support for additional information on technical support and training options.

See the ScanTools Suite System Requirements for further details on hardware and software requirements.

ScanTools is a suite of products; the specific information you want may appear in the help for a different module. If you don't find what you're looking for here, try one of the following:

  

Scantron Corporation

Customer Service (forms, products, and services):

1-800-SCANTRON (722-6876)

www.scantron.com

Technical Support:

1-800-445-3141

[email protected]

Copyright © 1998-2012 Scantron Corporation. All rights reserved. Use permitted only under license. www.scantron.com. No part of the Help or user guides may be reproduced in any form, or by any means, without express permission from Scantron Corporation.

LINKS TO THIRD PARTY SITES

This help system may contain links to third party websites ("Linked Sites"). The Linked Sites are not under the control of Scantron and Scantron is not responsible for the content of any Linked Site, including without limitation any link contained in a Linked Site or any changes or modifications to a Linked Site. Scantron is not responsible for web casting or any other form of transmission received from any Linked Site. Scantron provides Users with the ability to link the Assessment System to the Linked Sites as a convenience to you, and the inclusion of any link does not imply endorsement by Scantron of the Linked Site or any association with its operators.