You are here: Programmers Reference > Programmer's Reference > OmrHelper Interface > FrontBubbleOffsets

OmrHelper_FrontBubbleOffsets

Read-Write property.

Type: Array

There are as many elements in the array as bubbles – the first bubble is at index 0 and the last bubble is at an index 1 less than the bubble count.

When you write to this property you provide a new set of bubble locations. Do not change the number of bubbles.

.

Valid

See ScanEventArgs and ScanningManager Events Valid Combinations.

IDL

[propget] FrontBubbleOffsets([out, retval, satype("Location")] SAFEARRAY** pVal);

VB 6.0

[propput] FrontBubbleOffsets([in,satype("Location")] SAFEARRAY** newVal);

.Net

[propputref] FrontBubbleOffsets([in,satype("Location")] SAFEARRAY* newVal);

Values

Each element is a Location structure with members as follows:.

Location Description
Y member This is the Y-offset of the bubble from the timing mark on which it is located.
X member This is the distance of the center of the bubble measured from the inboard edge of the timing mark on which it is located.

 

 

 

See Help on Help for additional information on using this help file.

See Scantron Technical Support for additional information on technical support and training options.

See the ScanTools Suite System Requirements for further details on hardware and software requirements.

ScanTools is a suite of products; the specific information you want may appear in the help for a different module. If you don't find what you're looking for here, try one of the following:

  

Scantron Corporation

Customer Service (forms, products, and services):

1-800-SCANTRON (722-6876)

www.scantron.com

Technical Support:

1-800-445-3141

[email protected]

Copyright © 1998-2012 Scantron Corporation. All rights reserved. Use permitted only under license. www.scantron.com. No part of the Help or user guides may be reproduced in any form, or by any means, without express permission from Scantron Corporation.

LINKS TO THIRD PARTY SITES

This help system may contain links to third party websites ("Linked Sites"). The Linked Sites are not under the control of Scantron and Scantron is not responsible for the content of any Linked Site, including without limitation any link contained in a Linked Site or any changes or modifications to a Linked Site. Scantron is not responsible for web casting or any other form of transmission received from any Linked Site. Scantron provides Users with the ability to link the Assessment System to the Linked Sites as a convenience to you, and the inclusion of any link does not imply endorsement by Scantron of the Linked Site or any association with its operators.